How to Swap the 99 Series Headband in Minutes

By Meze Audio - Sound. Comfort. Design. True High-End. | Published: 2026-10-18

Category: Tips & Care

Replace your Meze 99 Classics or 99 Neo headband in a few simple steps. No tools needed, just a steady hand and a few minutes.

Quick answer

Swapping the 99 Series headband takes under five minutes and requires no tools. Simply slide off the old headband from the metal yokes, align the new one, and press it into place. The replacement headband is made from soft PU leather and fits both the 99 Classics and 99 Neo models.

Before You Start

The Meze 99 Series headband is designed for easy field replacement. It attaches to the metal yokes on each side with a simple friction fit — no screws, clips, or adhesive. This means you can refresh the look and feel of your headphones without any special skills or tools. Just make sure you have the correct replacement part: the standard 99 Series headband fits both the 99 Classics and the 99 Neo. If you own the 99 Classics Maple Silver edition, note that its headband uses protein leather instead of the standard PU leather, so confirm compatibility before ordering.

Step-by-Step Headband Swap

Remove the old headband: Hold the headphones by the ear cups. Gently pull one side of the headband away from the metal yoke — it will slide out with light pressure. Repeat on the other side. The headband is flexible, so you can bend it slightly to release it. Common mistake: pulling too hard or twisting the metal yoke. The yoke should stay straight. If the headband feels stuck, check that you are pulling parallel to the yoke, not at an angle.
Align the new headband: Take the replacement headband and line up the slot on one end with the metal yoke. The engraved text (’99 CLASSICS’ or ’99 NEO’) should face outward. Slide the yoke into the slot until it clicks or sits flush. Checkpoint: the headband should sit evenly on both sides. If one side is higher or lower, the slot may not be fully seated. Press firmly but gently until both sides are level.
Repeat on the other side: Slide the second yoke into the remaining slot. Ensure the headband is centered and the curve matches the shape of your head. Give each side a gentle tug to confirm it is secure. Final check: the headband should not wobble or slide. If it moves, remove and re-seat it. A properly installed headband will stay put during normal wear.

What You Need

99 SERIES HEADBAND: Standard Meze 99 series headband made from soft PU leather (pleather, ‘vegan’ leather, et al). Comes with two engravings, ’99 CLASSICS’ and ’99 NEO’. This single part works for both 99 Classics and 99 Neo models, so you don't need to worry about picking the wrong version. The soft PU leather is easy to clean and durable for daily use.